Wednesday, February 22, 2006

Auto Auctions In Fredericton

diy masonry heater how to make it work


adress I Shall now what i find The Most difficulty hand: how to make it clean and efficient work. First: If You Have To Have or plan a masonry heater, go ahead and buy yourself a good contact thermometer. I personnally use a Testo 925 http://www.testo.com/ fit with a contact probe. I am using it in two ways. Firstly, during the first month or so i would regularly monitor the temperatures within the firebox ( i drilled a small hole in the door frame for the probe ). With that i was able to see the difference in temperatures whith changing air intake. That is a good way to learn how much air you need at which stage of the fire. We will come to this later. Secondly, i take t° readings on 2 points of the surface of the heater which i have determined. One at the front and one at the side. I take these readings every mornings at 8.00. I note them on a spreadsheet together with useful informations ( outside t°, how many fires, etc...). That is also important because At the End of the day it Which Is The surface temperature radiate Into the rooms. I know it all Seems very silly goal i can assure you UNLESS You That Have Some sort of special bonds With The Gods Of Fire, This Is The Only Way to Learn about your masonry heater and flue clean about aussi. Next I Shall Deal With The Fire Itself and Will try to share my modest experience.

Here's how to make a good fire, efficient and propre.Tout First, if you are considering buying or building a PDM run you buy a good thermometer of contact. I have a Testo 925, with a probe www.testo.com contact.Je employed in 2 ways. First

to control combustion temperatures was inside the home. During the first month I very often measured temperatures depending on the settings of the air intake. I therefor drilled a small hole in the door frame to pass the probe thermometer. It is a very good system to learn quickly how much air you need and at what stage. We will return.

Then I take the surface temperature every morning on 2 points. One is located on the front and the other is on the side. I note all this on a sheet exell and various parameters (t ° exterior, wood quality etc..) I know it sounds childish but I do not think so because ultimately it is the heat radiated before us and do not forget that we are looking for the perfect combustion. The next time we see the technique of fire with a PDM.

0 comments:

Post a Comment